×
BE SO GOOD THEY CAN'T IGNORE YOU
--Your friends at LectureNotes
Close

Power Electronics

by Md Wesh Karni
Type: NoteInstitute: Veer Surendra Sai University Of Technology VSSUT Course: B.Tech Specialization: Electrical EngineeringDownloads: 188Views: 3875Uploaded: 10 months agoAdd to Favourite

Share it with your friends

Suggested Materials

Leave your Comments

Contributors

Md Wesh Karni
Md Wesh Karni
VEER SURENDRA SAI UNIVERSITY OF TECHNOLOGY BURLA, ODISHA, INDIA DEPARTMENT OF ELECTRICAL ENGINEERING Lecture Notes on Power Electronics Subject code – BEE1602 6th Semester B.Tech. (Electrical Engineering)
Disclaimer This document does not claim any originality and cannot be used as a substitute for prescribed textbooks. The information presented here is merely a collection by the committee members for their respective teaching assignments. Various sources as mentioned at the end of the document as well as freely available material from internet were consulted for preparing this document. The ownership of the information lies with the respective authors or institutions. Further, this document is not intended to be used for commercial purpose and the committee members are not accountable for any issues, legal or otherwise, arising out of use of this document. The committee members make no representations or warranties with respect to the accuracy or completeness of the contents of this document and specifically disclaim any implied warranties of merchantability or fitness for a particular purpose. The committee members shall be liable for any loss of profit or any other commercial damages, including but not limited to special, incidental, consequential, or other damages.
(6TH SEMESTER) POWER ELECTRONICS (3-1-0) MODULE-I (10 HOURS) Thyristors, Static V-I Characteristics of SCR, TRIAC, GTO & IGBT, Turn-On & Turn-OFF Mechanism of SCR, Gate Turnoff Thyristor (GTO) .Power BJTs . Power MOSFETs Insulated Gate Bipolar Transistors (IGBTs) - Basic Structure and VI Characteristics. Static, dynamic and thermal characteristics. Protection, cooling and mounting techniques. Series and Parallel operation of devices. Triggering and basics of driver circuits. Different types of commutation schemes: Natural and Forced commutation. MODULE-II (10 HOURS) 1-Phase Half & Full Wave Controlled Rectifier with various kinds of loads (R, R-L-E (motor)). Midpoint and Bridge type converters. Half Controlled and Fully Controlled Bridge circuits, different waveforms, Input Line Current Harmonics, Power factor, current distortion and displacement factorsInverter Mode of Operation. Continuous and discontinuous modes, Effect of source inductance assuming constant load current. Effect of freewheeling diode. Three phase bridge converters for different types of load with constant load current, different waveforms. 180 and 120 degree operations. MODULE-III (10 HOURS) DC-DC Converters: Classification of types of choppers, One, Two and Four quadrant operations, Step up and down choppers, Analysis of Type-A chopper, Single-and two quadrant operation with DC motor load. AC-AC Converters: Single-phase mid-point and bridge types of step-up and step-down Cycloconverters. Single phase AC Voltage regulators and its basic analysis. MODULE-IV (10 HOURS) Single-phase Half and Full bridge Inverter, Pulse Width Modulated (PWM) technique for voltage control, SPWM Technique 1-phase inverters, Auxiliary Commutated (Mc-Murray) and Complementary Commutated (Mc-Murray Bedford) Inverters, Three-phase Voltage Source Bridge type of Inverters. (120 and 180 Degree conduction modes), Current Source Inverter. Applications: UPS, SMPS, Induction Heating, Electronic Ballast, AC/DC drives speed control.

Lecture Notes