LECTURE NOTES ON ADVANCED FOUNDATION ENGINEERING (A70134) IV B. Tech I semester (JNTUH-R13) CIVIL ENGINEERING
UNIT - I BEARING CAPACITY OF SOIL Definitions Bearing capacity is the power of foundation soil to hold the forces from the superstructure without undergoing shear failure or excessive settlement. Foundation soil is that portion of ground which is subjected to additional stresses when foundation and superstructure are constructed on the ground. The following are a few important terminologies related to bearing capacity of soil. Ground Level Super Structure Foundation Foundation Soil Fig. 7.1 : Main components of a structure including soil Ultimate Bearing Capacity (qf) : It is the maximum pressure that a foundation soil can withstand without undergoing shear failure. Net ultimate Bearing Capacity (qn) : It is the maximum extra pressure (in addition to initial overburden pressure) that a foundation
soil can withstand without undergoing shear failure. qn = qf - qo Here, qo represents the overburden pressure at foundation level and is equal to үD for level ground without surcharge where ү is the unit weight of soil and D is the depth to foundation bottom from Ground Level. Safe Bearing Capacity (qs) : It is the safe extra load the foundation soil is subjected to in addition to initial overburden pressure. qs qn qo F Here. F represents the factor of safety. Allowable Bearing Pressure (qa) : It is the maximum pressure the foundation soil is subjected to considering both shear failure and settlement. Foundation is that part of the structure which is in direct contact with soil. Foundation transfers the forces and moments from the super structure to the soil below such that the stresses in soil are within permissible limits and it provides stability against sliding and overturning to the super structure. It is a transition between the super structure and foundation soil. The job of a geotechnical engineer is to ensure that both foundation and soil below are safe against failure and do not experience excessive settlement. Footing and foundation are synonymous. Modes of shear failure Depending on the stiffness of foundation soil and depth of foundation, the following are the modes of shear failure experienced by the
foundation soil. 1. General shear failure (Ref Fig. 7.1a) 2. Local shear failure (Ref Fig. 7.1b) 3. Punching shear failure (Ref Fig. 7.1c) Shear failure in foundation soil P – Δ curve in different foundation soils Fig. 7. 1 : Footing on ground that experiences a) General shear failure, b) Local shear failure and c) Punching shear failure General Shear Failure This type of failure is seen in dense and stiff soil. The following are some characteristics of general shear failure. 1. Continuous, well defined and distinct failure surface develops between the edge of footing and ground surface. 2. Dense or stiff soil that undergoes low compressibility experiences this failure. 3. Continuous bulging of shear mass adjacent to footing is visible. 4. Failure is accompanied by tilting of footing. 5. Failure is sudden and catastrophic with pronounced peak in P – Δ curve. 6. The length of disturbance beyond the edge of footing is large.