×
If you can dream it, you can do it.
--Your friends at LectureNotes
Close

Power Plant Engineering

by Amity Kumar
Type: NoteInstitute: Amity University Specialization: Electronics and Instrumentation EngineeringOffline Downloads: 106Views: 2929Uploaded: 8 months agoAdd to Favourite

Share it with your friends

Suggested Materials

Leave your Comments

Contributors

Amity Kumar
Amity Kumar
POWER PLANT INSTRUMENTATION UNIT-I INTRODUCTION TO POWER PLANTS AND BOILERS STEAM POWER PLANT: A thermal power station is a power plant in which the prime mover is steam driven. Water is heated, turns into steam and spins a steam turbine which drives an electrical generator. After it passes through the turbine, the steam is condensed in a condenser and recycled to where it was heated; this is known as a Rankine cycle. The greatest variation in the design of thermal power stations is due to the different fuel sources. Some prefer to use the term energy center because such facilities convert forms of heat energy into electricity. Some thermal power plants also deliver heat energy for industrial purposes, for district heating, or for desalination of water as well as delivering electrical power. A large proportion of CO2 is produced by the worlds fossil fired thermal power plants; efforts to reduce these outputs are various and widespread. 3
The four main circuits one would come across in any thermal power plant layout are -Coal andAshCircuit -AirandGasCircuit Feed Water and Steam Circuit Cooling Water Circuit Coal and Ash Circuit Coal and Ash circuit in a thermal power plant layout mainly takes care of feeding the boiler with coal from the storage for combustion. The ash that is generated during combustion is collected at the back of the boiler and removed to the ash storage by scrap conveyors. The combustion in the Coal and Ash circuit is controlled by regulating the speed and the quality of coal entering the grate and the damper openings. Air and Gas Circuit Air from the atmosphere is directed into the furnace through the air preheated by the action of a forced draught fan or induced draught fan. The dust from the air is removed 4
before it enters the combustion chamber of the thermal power plant layout. The exhaust gases from the combustion heat the air, which goes through a heat exchanger and is finally let off into the environment. Feed Water and Steam Circuit The steam produced in the boiler is supplied to the turbines to generate power. The steam that is expelled by the prime mover in the thermal power plant layout is then condensed in a condenser for re-use in the boiler. The condensed water is forced through a pump into the feed water heaters where it is heated using the steam from different points in the turbine. To make up for the lost steam and water while passing through the various components of the thermal power plant layout, feed water is supplied through external sources. Feed water is purified in a purifying plant to reduce the dissolve salts that could scale the boiler tubes. Cooling Water Circuit The quantity of cooling water required to cool the steam in a thermal power plant layout is significantly high and hence it is supplied from a natural water source like a lake or a river. After passing through screens that remove particles that can plug the condenser tubes in a thermal power plant layout, it is passed through the condenser where the steam is condensed. The water is finally discharged back into the water source after cooling. Cooling water circuit can also be a closed system where the cooled water is sent through cooling towers for re-use in the power plant. The cooling water circulation in the condenser of a thermal power plant layout helps in maintaining a low pressure in the condenser all throughout. All these circuits are integrated to form a thermal power plant layout that generates electricity to meet our needs. LAYOUT OF HYDEL POWER PLANT: 5
Hydroelectric power plants convert the hydraulic potential energy from water into electrical energy. Such plants are suitable were water with suitable head are available. The layout covered in this article is just a simple one and only cover the important parts of hydroelectric plant.The different parts of a hydroelectric power plant are (1) Dam Dams are structures built over rivers to stop the water flow and form a reservoir.The reservoir stores the water flowing down the river. This water is diverted to turbines in 6

Lecture Notes