Hard work beats talent when talent doesn’t work hard.
--Your friends at LectureNotes

Advanced Electronic Circuits

by Sumanta Kumar Munda
Type: NoteDownloads: 8Views: 814Uploaded: 3 months agoAdd to Favourite

Touch here to read

Advanced Electronic Circuits by Sumanta Kumar Munda

Sumanta Kumar Munda
Sumanta Kumar Munda

/ 54

Share it with your friends

Suggested Materials

Leave your Comments


Sumanta Kumar Munda
Sumanta Kumar Munda
Disclaimer This document does not claim any originality and cannot be used as a substitute for prescribed textbooks. The information presented here is merely a collection by the committee members for their respective teaching assignments. Various sources of the document as well as freely available material from internet were consulted for preparing this document. The ownership of the information lies with the respective authors or institutions. Further, this document is not intended to be used for commercial purpose and the committee members are not accountable for any issues, legal or otherwise, arising out of use of this document. The committee members make no representations or warranties with respect to the accuracy or completeness of the contents of this document and specifically disclaim any implied warranties of merchantability or fitness for a particular purpose. The committee members shall be liable for any loss of profit or any other commercial damages, including but not limited to special, incidental, consequential, or other damages.
ELECTRONICS CIRCUITS (3-1-0) MODULE-I Diode circuit: Load line concept, clipping circuits, comparators, sampling gate, rectifiers, capacitive filters, additional diode circuit. Transistor: the junction transistor, transistor as an amplifier, transistor construction, the CE configuration, the CB configuration, the CE cut-off and saturation region, common emitter current gain, the common collector configuration, analytical expression for transistor characteristics, the phototransistor. Transistor at low frequency: Graphical analysis of the CE model, two-port model and hybrid model, transistor hybrid model, the h-parameter, analysis of transistor amplifier circuit using hparameter, the emitter follower, miller’s theorem and its duality, cascading transistor amplifiers, simplified CE and CC configuration. MODULE-II (10 Lectures) Junction FET and its V-I characteristics, FET small signal model, FET biasing, MOSFET, FET as a voltage-variable resistor (VVR), CD amplifier, the hybrid-pi CE transistor model, hybrid-pi conductance and capacitance, validity of hybrid-pi model, variation of hybrid-pi parameters, the CE short-circuit current gain, current gain with resistive load, single stage CE transistor amplifier response, emitter follower at high frequency. Classification of amplifier, distortion in amplifier, frequency response of amplifier, bode plots, step response of amplifier, band pass of cascade stages, the RC coupled amplifier, high frequency response of two cascaded CE transistor stages. MODULE-III (10 Lectures) Classification of amplifier, feedback concept, transfer gain, negative feedback, input-output resistance, method of analysis of a feedback amplifier, voltage- series, voltage-shunt, currentseries and current shunt feedback, effect of feedback on bandwidth, double and three pole transfer function with feedback, approximation analysis of multi-pole feedback, voltage-series, voltage-shunt, current- series and current-shunt frequency response, stability, gain and phase margin, compensation, different type of oscillator, frequency stability. MODULE-IV (10 Lectures) The basic operational amplifier (OPAMP), differential amplifier and its transfer characteristics, emitter coupled differential amplifier, IC-OPAMP, offset error voltage and current, temperature drift of input offset voltage and current, measurement of OPAMP parameter and its frequency response, different type of OPAMP compensation and its step response. Basic OPAMP application, differential DC amplifier, AC amplifier, analog integrator and differentiator, active filter, resonant band-pass filter, delay equalizer, comparators, sample-hold circuit, AC/DC convertors, logarithmic amplifier, Schmitt trigger, ECL, TTL and 555-timer. BOOKS: 1. Millma. J. and Halkias .C. Integrated Electronics, TMH, 2007. 2. S. Salivahanan, N. Suresh Kumar and A. Vallavaraj, Electronic Devices and Circuits, 2nd Edition, TMH, 2007. 3. Robert L. Boylestad and Louis Nashelsky, Electronic Devices and Circuit Theory, 9th Edition, Pearson Education / PHI, 2007.
CHAPTER-1 (Lecture-1 & 2) 1.1The The Diode as a Circuit Element Diodes are referred to as non-linear linear circuit elements because of the diode characteristic curve i.e. = ( -1) 1) ...(1.1) Where =reverse saturation current in the range of pA for low-power low power diode. = is thermal voltage(about 26 mV at room ttemperature, emperature, T = 300 K). =ideality factor(1< <2). Figure 1.1: a) Circuit symbol for a diode and b) current current versus voltage for a semiconductor diode. For most applications the non-linear non linear region can be avoided and the device can be modeled by piece-wise wise linear circuit elements. Qualitatively we can just think of an ideal diode has having two regions: a conduction region of zero resistance and an infinite resistance non-conduction non region. For many circuit applications, this ideal diode diode model is an adequate representation of an actual diode and simply requires that the circuit analysis be separated into two parts: forward

Lecture Notes