×

Close

- Circuits and Devices - CD
- Practical
- 17 Experiments
**495 Views**- 7 Offline Downloads
- Uploaded 6 months ago

Touch here to read

Page-1

- Introduction and Syllabus - ( 1 - 2 )
- Verification of KVL & KCL - ( 3 - 8 )
- Verification of Thevenin & Norton's Theorems - ( 9 - 16 )
- Superposition Theorem - ( 17 - 20 )
- Verification of Maximum Power Transfer & reciprocity Theorems - ( 21 - 27 )
- Frequency Response of Resonance Circuit - ( 28 - 32 )
- Characteristics of PN Diode - ( 33 - 38 )
- Characteristics of Zener Diode - ( 39 - 43 )
- Characteristics of BJT in CE Configuration - ( 44 - 49 )
- Characteristics of BJT in CB Configuration - ( 50 - 55 )
- Characteristics of SCR - ( 56 - 60 )
- Characteristics of UJT - ( 61 - 64 )
- Characteristics of JFET and MOSFET - ( 65 - 74 )
- Characteristics of DIAC and TRIAC - ( 75 - 83 )
- Characteristics of Photo Diode and Photo Transistor - ( 84 - 89 )
- Transient analysis of RL and RC Circuits - ( 90 - 93 )
- Clipper and Clamper & FWR - ( 94 - 103 )

Experiment:

ANNA UNIVERSITY, Chennai 2013 REGULATION DEPARTMENT OF ELECTRONICS & COMMUNICATION ENGG. EC6211 CIRCUITS AND DEVICES LABORATORY (I B.E II Semester Batch 2013) V+ TEAM

EC6211 CIRCUITS AND DEVICES LABORATORY List of Experiments 1. Verification of KVL & KCL. 2. Verification of Thevenin & Norton’s Theorems. 3. Verification of Superposition Theorem. 4. Verification of Maximum Power Transfer & reciprocity Theorems. 5. Frequency response of series & parallel resonance circuits. 6. Characteristics of PN 7. Characteristics of Zener diode. 8. Characteristics of CE configuration. 9. Characteristics of CB configuration. 10. Characteristics of SCR. 11. Characteristics of JFET & MOSFET. 12. Transient analysis of RL and RC circuits 13. Clipper and Clamper & FWR V+ TEAM

WWW.VIDYARTHIPLUS.COM KIRCHOFF’S VOLTAGE LAW EX. NO: 1(a) AIM: To verify the Kirchoff’s Voltage Law (KVL) for the given circuit. APPARATUS REQUIRED: S.NO APPARATUS 1 RPS 2 Resistor 3 Voltmeter 4 5 TYPE RANGE QUANTITY DC (0-30)V 1 - 1KΩ 3 DC (0-10)V 3 Bread board - - 1 Connecting wires - - Few FORMULA USED: 1. CURRENT DIVISION RULE: I = TOTAL CURRENT X OPPOSITE RESISTANCE TOTAL RESISTANCE 2. OHM’S LAW: V=IR Where, V = Voltage in Volts I = Current in Amperes R = Resister in Ohms THEORY: KIRCHOFF’S VOLTAGE LAW: It states that the algebraic sum of all the voltages in a closed loop is equal to zero. ∑V = 0 V+ TEAM

WWW.VIDYARTHIPLUS.COM CALCULATION: = 1K = 1K ; = 1K Let V = 5V, I1= I*R2 R1+R2 V1=I1*R1 In the loop ABEFA, Circuit Diagram for Kirchoff’s Voltage Law PROCEDURE: KIRCHOFF’S VOLTAGE LAW: 1. The circuit connections are given as per the circuit diagram. 2. Switch ON the power supply. 3. Initially set 5V as input voltage from RPS. 4. The voltmeter readings are noted and the values are tabulated. 5. The same procedure is repeated for various values. WWW.VIDYARTHIPLUS.COM V+ TEAM

## Leave your Comments